Sparkle dust cuff bracelet kit
Make this fabulous crystal bracelet using crystal tubing and fine quality crystal end caps.
19cm crystal tubing
1 loop of memory wire
2 end caps
2 crystal fla tbacks
Instructions: to make the most popular size
Cut crystal tubing between 16 and 17 cm's
Thread onto memory wire using 2 pieces of memory wire for better tension
Trim memory wire at end of tubing
Glue on end cap (E6000 glue is recommended)
Glue on crystal flat back (E6000 glue is recommended)
Leave 24 hours for glue to cure
Please note tubing is supplied longer than the average size wrist allowing you to make a bigger bracelet if needed.