Acrylic bling cuff bracelet kit - Red
£3.00
Contents:
1 x 3 x 17.5cms Acrylic Diamond bling 4mm square sheet
1 x 3 x 17.5cms felt sheet
1 x 33cm x 33cm Magnetic heart Clasp - Rhodium plated
Addition materials needed: (not included)
E6000 Glue
Watch / spectacles screw driver
Scissors
Instructions:
1. Place one end of acrylic sheet into the clasp and temporary screw in lightly, wrap around your wrist to find the size that suits you best, mark this point with a marker pen then cut with scissors.
2. Cut the black felt sheet to the size of the acrylic sheet, then remove backing on the sheet and stick it onto the felt.
3. Put both ends of the acrylic sheet in the clasp and screw in lightly, try on for size.
4. When you have the correct size remove the acrylic sheet from the clasp.
5. Place some E6000 glue inside the clasp then insert acrylic strip making sure the edges are straight tighten the screws.
6. Leave 24 hours for the glue to cure
1 x 3 x 17.5cms Acrylic Diamond bling 4mm square sheet
1 x 3 x 17.5cms felt sheet
1 x 33cm x 33cm Magnetic heart Clasp - Rhodium plated
Addition materials needed: (not included)
E6000 Glue
Watch / spectacles screw driver
Scissors
Instructions:
1. Place one end of acrylic sheet into the clasp and temporary screw in lightly, wrap around your wrist to find the size that suits you best, mark this point with a marker pen then cut with scissors.
2. Cut the black felt sheet to the size of the acrylic sheet, then remove backing on the sheet and stick it onto the felt.
3. Put both ends of the acrylic sheet in the clasp and screw in lightly, try on for size.
4. When you have the correct size remove the acrylic sheet from the clasp.
5. Place some E6000 glue inside the clasp then insert acrylic strip making sure the edges are straight tighten the screws.
6. Leave 24 hours for the glue to cure
Specifications
Condition
New