Diamante crystal bling cuff bracelet kit - 10mm faceted black square glass+2mm diamante clear stone -- c4009035kit

1 x 3cm x 16 cms Diamante crystal sheet ( for longer lengths please us the drop down box)
1 x 3cm x 18 cms felt sheet 
1 x 33cm x 33cm Magnetic heart Clasp - Rhodium plated

Addition materials needed: (not included)
E6000 Glue
Watch / spectacles screw driver

1. Place one end of the diamante sheet into the clasp and temporary screw in lightly, wrap around your wrist to find the size that suits you best, mark this point with a marker pen then cut with scissors.
2. Cut the black felt sheet to the size of the diamante sheet.
3. Place diamante sheet onto the felt, position carefully then lightly hold a hot iron on top of the diamante sheet for approximately 60 seconds by this time the backing glue should have melted and attached itself to the felt.
4. Put both ends of the diamante sheet into the clasp and screw in lightly, try on for size.
4. When you have the correct size remove the diamante sheet from the clasp.
5. Place some E6000 glue inside the  clasp then insert diamante strip making sure the edges are straight tighten the screws.
6. Leave 24 hours for the glue to cure

When using a hot iron please read the safety instructions supplied with your iron.


Condition New
product review overlay image

Customer reviews

No reviews left yet
Write A Review

No reviews have been left for this product, be the first to leave a review