-8213-p.jpg?v=b3a10c2e-a222-434f-9bbe-3c30ba15ee19)
Diamante crystal bling cuff bracelet kit - grey -- 5000050kit
£7.00
Contents:
1 x 3cm x 16 cms Diamante crystal sheet ( for longer lengths please us the drop down box)
1 x 3cm x 18 cms felt sheet
1 x 33cm x 33cm Magnetic heart Clasp - Rhodium plated
Addition materials needed: (not included)
E6000 Glue
Watch / spectacles screw driver
Scissors
Iron
Instructions:
1. Place one end of the diamante sheet into the clasp and temporary screw in lightly, wrap around your wrist to find the size that suits you best, mark this point with a marker pen then cut with scissors.
2. Cut the black felt sheet to the size of the diamante sheet.
3. Place diamante sheet onto the felt, position carefully then lightly hold a hot iron on top of the diamante sheet for approximately 60 seconds by this time the backing glue should have melted and attached itself to the felt.
4. Put both ends of the diamante sheet into the clasp and screw in lightly, try on for size.
4. When you have the correct size remove the diamante sheet from the clasp.
5. Place some E6000 glue inside the clasp then insert diamante strip making sure the edges are straight tighten the screws.
6. Leave 24 hours for the glue to cure
When using a hot iron please read the safety instructions supplied with your iron.
1 x 3cm x 16 cms Diamante crystal sheet ( for longer lengths please us the drop down box)
1 x 3cm x 18 cms felt sheet
1 x 33cm x 33cm Magnetic heart Clasp - Rhodium plated
Addition materials needed: (not included)
E6000 Glue
Watch / spectacles screw driver
Scissors
Iron
Instructions:
1. Place one end of the diamante sheet into the clasp and temporary screw in lightly, wrap around your wrist to find the size that suits you best, mark this point with a marker pen then cut with scissors.
2. Cut the black felt sheet to the size of the diamante sheet.
3. Place diamante sheet onto the felt, position carefully then lightly hold a hot iron on top of the diamante sheet for approximately 60 seconds by this time the backing glue should have melted and attached itself to the felt.
4. Put both ends of the diamante sheet into the clasp and screw in lightly, try on for size.
4. When you have the correct size remove the diamante sheet from the clasp.
5. Place some E6000 glue inside the clasp then insert diamante strip making sure the edges are straight tighten the screws.
6. Leave 24 hours for the glue to cure
When using a hot iron please read the safety instructions supplied with your iron.
Specifications
Condition
New